DTED manipulations
ali devin sezer (e106184++at++metu.edu.tr)
Tue, 7 Dec 1999 14:51:11 +0200 (WET)
I installed performer on my Linux box and have been tinkering
with it for the last month. I want to use the DTED db library to read
my DTED files. IT works wonderfully however I could not figure
out how I can learn the internals- I can look at the
code but before delving into that I just wanted to ask- is
there an easy way of understanding the structure of the graph
that library
creates from a DTED file it reads? I used pfPrint to print out
the graph but I couldn't make much sense out of it. For instance
I want to do texture mapping, I want to see for which geosets
I will enable texture mapping- and things like this. if these are
all too obvious
things and I couldn't figure out because I didn't look well(
I hope I did :) into
the documentation ( the programmer guides + the mailing list archives)
then could you give me a starting point for doing further reading?
This is my first posting- I thank everyone for his/her reply
Sincerely
Devin Sezer
This archive was generated by hypermail 2.0b2
on Tue Dec 07 1999 - 04:51:53 PST