Paul S. Cutt (cutt++at++netcom.com)
Thu, 7 Oct 1999 15:09:29 -0700 (PDT)
We nornally compile on Indigo2 under 6.2 and run without problems
on 6.3 and 6.5 on Onyx as well as O2.
Could you provide some detials on the XvsLink version (off line) ?
Thanks,
paul
On Thu, 7 Oct 1999, Ulrich Hertlein wrote:
> vossg++at++igd.fhg.de wrote:
> > > I'm attempting to access a Logitech SpaceMouse and wrote a couple of
> > > test apps to access the port directly and through XVS-Link. They work
> > > fine on an Indigo2 running IRIX 6.3 and Linux but don't work at all
> > > under IRIX 6.5.5.
> >
> > Yep, if I recall it right the baud rate is set different.
> >
> > Up to 6.3 the following was used :
> >
> > port_setup.c_cflag |= B9600;
> >
> > Starting with 6.4 there are a seperate entry for the io speeds :
> >
> > port_setup.c_ospeed = B9600;
> > port_setup.c_ispeed = B9600;
> >
> > You should also check the baud defines, I think they changed them too.
>
> I'm actually using cfsetispeed(3t) and cfsetospeed(3t), which as I
> understand handle these things properly. I assume that the XVS-Link
> library does this similar.
>
> -Ulrich
>
> --
> Ulrich Hertlein | "The trouble with having an
> q~bus Mediatektur GmbH | open mind is that people come
> mailto:u.hertlein++at++q-bus.de | along and put things in it."
> -----------------------------------------------------------------------
> List Archives, FAQ, FTP: http://www.sgi.com/software/performer/
> Submissions: info-performer++at++sgi.com
> Admin. requests: info-performer-request++at++sgi.com
>
This archive was generated by hypermail 2.0b2 on Thu Oct 07 1999 - 15:10:18 PDT