Re: Dashed lines?

New Message Reply Date view Thread view Subject view Author view

Tze Lin Ong (tzelin++at++cthulhu.engr.sgi.com)
Mon, 26 Jul 1999 08:24:55 -0700

In draw callbacks you can use pfuPreDrawStyle and pfuPostDrawStyle
to set and unset, respectively, the drawing of polygons as points,
lines, dashed, haloed, etc.

Cheers,
tzelin

Albert Khakshour wrote:
>
> Hello all. Is there any easy way to create dotted or dashed
> lines in Performer? I know I can probably use glLineStipple
> in a draw callback, but I'd rather not go through all that if
> there's a flag somewhere that does it. Thanks.
>
> Albert
>
> /---------------------------------------------------\
> | Albert Khakshour -- akhaksho++at++ncsa.uiuc.edu |
> | Visualization and Virtual Environments |
> | National Center for Supercomputing Applications |
> | 5209 Beckman Institute -- (217) 265 8142 |
> \---------------------------------------------------/
>
> -----------------------------------------------------------------------
> List Archives, FAQ, FTP: http://www.sgi.com/software/performer/
> Submissions: info-performer++at++sgi.com
> Admin. requests: info-performer-request++at++sgi.com

-- 
Tze Lin Ong           SGI
Advanced Graphics     2011 N Shoreline, MS 8L-525
Applied Engineering   Mt View, CA 94043
Tel: (650) 933 5267   Fax: (650) 932 0511

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Jul 26 1999 - 08:25:02 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.