Mark Aubin (aubin++at++mustang.engr.sgi.com)
Wed, 16 Jun 1999 07:44:04 -0700 (PDT)
This is most likely a problem related to the upgrade, and not Performer.
I have not heard of any problems with this particular combination
and we have done the same upgrade on a number of Onyx2 IR systems.
Can you please provide more information on the failure?
You can set the PFNFYLEVEL environment variable to 7 for maximum
debug messages and then run your application. This will give us
any errors if they are Performer related.
Also, have you tried running other applications on your Onyx2
after the upgrade? If not, please try a few other apps. This
may reveal a missing library, or incompatible library. I'm thinking
that the upgrade didn't happen completely. Sometimes certain
subsystems are removed during the upgrade, but their replacements
are on different CD's which didn't get installed.
--Mark Aubin
aubin++at++sgi.com
On Jun 16, 4:21pm, Ran K wrote:
> Subject: Irix 6.5 & Clip-Map problems
> Hi,
> We have just upgraded our Onyx2 IR from Irix 6.4 to Irix 6.5.3 and
> from Performer 2.2.2 to Performer 2.2.4
> After the upgrade we couldn't run any Clip-Map applications we had
> and we couldn't even run the Yosmite Demo that's included.
>
> Are there any known problems with Clip-Maps on Irix 6.5 ?
> Is there any "safe" combination of Irix 6.5.x & Performer 2.2.x that
> has no problems with Clip-Maps?
>
> Ran
> -----------------------------------------------------------------------
> List Archives, FAQ, FTP: http://www.sgi.com/software/performer/
> Submissions: info-performer++at++sgi.com
> Admin. requests: info-performer-request++at++sgi.com
>-- End of excerpt from Ran K
This archive was generated by hypermail 2.0b2 on Wed Jun 16 1999 - 07:44:08 PDT