flip view

New Message Reply Date view Thread view Subject view Author view

Dirk Scheffter (scheff++at++ue.iff.fhg.de)
Tue, 8 Jun 1999 14:29:57 -0600

Hi there,

To setup a view with known eye position and screen dimensions I used
pfChannel::makePersp to produce a correct look into virtual world. The result
was OK.
Due to technical causes the configuration of our beamer has changed and it
produces now a horizontally flipped view (from right to left). Therefore I
exchanged the x-coords for left and right border. Unfortunately, the assigned
pfChannel displays now only lines. All faces are invisible.
How can I make faces visible again.
Is it necessary/possible to change front face mode from GL_CCW to GL_CW? If so
is there a possibility to override this mode changing per channel/scene?
Any ideas are welcome.

pfGreetings,
Dirk.

-- 
-----------------------------------------------------------
Dipl.-Inf. Dirk Scheffter                 scheff++at++iff.fhg.de       
Fraunhofer IFF                   fon: +49 (0) 391/40 90-854
Sandtorstr. 22                   fax: +49 (0) 391/40 90-870
D-39106 Magdeburg           http://wwwue.iff.fhg.de/~scheff   
Germany             
----------< Try this: http://wwwue.iff.fhg.de/ibft/mowib >-

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Tue Jun 08 1999 - 05:31:53 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.