Rob Jenkins (robj++at++sgi.com)
Thu, 20 May 1999 04:30:42 -0700
We and our customer are using SGI Onyx2 with two pipes to building a
CAVE system for VR research. We have installed C++, Open-invntor and
Performer on Onyx2. Now we
want to outport 3D image files to channel0 and channel1 of pipe0 and
pipe1.This must be done by application programme.Would you tell me which
command can finish it?
Regards
Quick Qian
Sea Stars company
"
You should be able to do something like this with perfly, see perfly -h
for the full options but it would be something like:
perfly -c 4 -M 1 <modelname>
This will give you 4 channels and multipipe but I'm sure how the
channels will split over pipes, the perfly and multipipe/multichan
samples under /usr/share/Performer/src will show detail to let you set
up your own pipe/channel mapping.
Cheers
Rob
-- ________________________________________________________________ Rob Jenkins SGI Graphics Consulting Tel 0118 925 7621 mailto:robj++at++sgi.com http://www.sgi.co.uk
This archive was generated by hypermail 2.0b2 on Thu May 20 1999 - 05:28:08 PDT