How to display the pfGeoSet

New Message Reply Date view Thread view Subject view Author view

Mr li Yonglin (engp8691++at++nus.edu.sg)
Tue, 11 May 1999 19:04:25 -0700

Hi, performers
        I am trying to construct my own pfGeoSet so that I can control it
easily. I did it well in iris6.2 but after I transfered my codes from
iris6.2 to iris6.4 I found my programs cannot compile and run. Then I
use the codes in /usr/share/Performer/src/sample/C++/perfly and
/usr/share/Performer/src/sample/C++/common plus my own programs to
recompile and link. But it is funny that I can not see any thing on the
screen. But the code I used can display my own pfGeoSets well on
iris6.2.
        So any body knows how to display the objects of your own pfGeoSet. For
example. How to construct and display a cube in perfly using your own
codes. Especially how to display?

Thanks in advance.

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Tue May 11 1999 - 03:02:28 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.