Re: Indigo & IRIX 6.5

New Message Reply Date view Thread view Subject view Author view

Tze Lin Ong (tzelin++at++cthulhu.engr.sgi.com)
Thu, 04 Feb 1999 08:35:16 -0800


Hi Dirk,

IRIX 6.5 does not support any CPU earlier than the R4000 series.
So, unfortunately, it will not install on this system you have.

Cheers,
tzelin

Dirk Scheffter wrote:

> Hello there,
>
> Sorry, this question is of course off the topic. Perhaps somebody can help me
> for all that.
>
> Does IRIX 6.5 run at an Indigo? (not Indigo2)
>
> >hinv
>
> 1 30 MHZ IP12 Processor
> FPU: MIPS R2010A/R3010 VLSI Floating Point Chip Revision: 4.0
> CPU: MIPS R2000A/R3000 Processor Chip Revision: 3.0
> On-board serial ports: 2
> Data cache size: 32 Kbytes
> Instruction cache size: 32 Kbytes
> Main memory size: 16 Mbytes
> Integral Ethernet: ec0, version 0
> CDROM: unit 3 on SCSI controller 0
> Disk drive: unit 2 on SCSI controller 0
> Disk drive: unit 1 on SCSI controller 0
> Integral SCSI controller 0: Version WD33C93B, revision C
> Iris Audio Processor: revision 10
> Graphics board: GR2-XS
>
> >gfxinf
>
> Graphics board 0 is "GR2" graphics.
> Managed (":0.0") 1280x1024
> 1 GE, 8 bitplanes, 4 auxplanes, 4 cidplanes, no Z-buffer
> GR2 revision 2, VB1.1
> HQ2 rev A, GE7 rev B, RE3 rev D, VC1 rev B, PIC rev 1.5
> unknown, assuming 19" monitor
>
> This machine seems to be a little bit older... :-)
>
> Greetings,
> Dirk.
>
> --
> -----------------------------------------------------------
> Dipl.-Inf. Dirk Scheffter scheff++at++iff.fhg.de
> Fraunhofer IFF fon: +49 (0) 391/40 90-854
> Sandtorstr. 22 fax: +49 (0) 391/40 90-870
> D-39106 Magdeburg http://wwwue.iff.fhg.de/~scheff
> Germany
> ----------< Try this: http://wwwue.iff.fhg.de/ibft/mowib >-
> =======================================================================
> List Archives, FAQ, FTP: http://www.sgi.com/software/performer/
> Submissions: info-performer++at++sgi.com
> Admin. requests: info-performer-request++at++sgi.com


New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Thu Feb 04 1999 - 08:35:21 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.