Re: dof in perfly

New Message Reply Date view Thread view Subject view Author view

Marcus Barnes (marcus++at++multigen.com)
Mon, 4 Jan 1999 12:28:47 -0800

On Dec 31, 1:35pm, Mario Veraart wrote:
>On Dec 27, 4:08am, chuan tian wrote:
>>I made a dof model in multigen II pro, and established the linkage
>>among the attributes of beads. How can I make it work in perfly?
>>in other words, how can I make the degree of freedom(dof) feature work.
>
>Read the man pages and/or the readme file that comes with the flight
>loader for performer on how to process the DOF bead in the flight
>callback. When you have the reference to the pfDCS and the matrices
>(for addition transformation) you can set the pfDCS matrix every
>frame to the value you need.

Specifically read the man page for pfdConverterAttr_flt() and fltRegisterNodeT.

Also if you are really asking how to enable Behavior linkages in perfly then
read the man page for pfdConverterMode_flt(). You would need to enable the mode
PFFLT_BEHAVIORS ... i.e. "perfly -y flt,26,1 file.flt".

Regards.

--
+ Marcus Barnes, Technical Staff        mailto:marcus++at++multigen.com +
+ Multigen-Paradigm Inc.                http://www.multigen.com    +
+ 550 S. Winchester Blvd.               phoneto:1-408-367-2654     +
+ Suite 500 San Jose CA 95128           faxto:1-408-261-4103       +

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Jan 04 1999 - 12:27:39 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.