Re: 3D data

New Message Reply Date view Thread view Subject view Author view

Roy Ruddle (Ruddle++at++cardiff.ac.uk)
Thu, 5 Nov 1998 14:23:14 +0000 (GMT)

> does anyone know of any tools to convert a file of raw 3D data (XYZ
> coordinates separated by spaces)
> into Performer/DXF/Inventor. The data has no grouping such as triangle
> stripsets/quadmeshes etc. so I just need to display this as points.
>
It would be trivial to write a little programme that converts your raw
data into Inventor format, e.g.:

#Inventor V2.0 ascii
Separator {
 Coordinate3 { point [0 0 0, 10 0 0]}
 PointSet{}
}

roy

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Thu Nov 05 1998 - 06:24:09 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.