Re: pfb models

New Message Reply Date view Thread view Subject view Author view

Dave Pape (pape++at++evl.uic.edu)
Tue, 20 Oct 1998 23:39:25 -0500 (CDT)


On Tue, 20 Oct 1998, Costas Korsnick wrote:
>
> I am looking for conversion programs to convert models in Softimage
> (.hrc) and Inventor (.iv) formats to Performer (.pfb).

For Softimage, you can find my Performer .hrc loader at
http://www.evl.uic.edu/pape/sw/pfsoft/.
I wrote it because we've had a lot of problems with SoftimageToIv in
the past. The web page describes the elements of Softimage that it
supports, and the steps necessary to use it.

 -Dave

---------------------------------------------------------------------------
Dave Pape Electronic Visualization Laboratory, UIC
pape++at++evl.uic.edu http://www.evl.uic.edu/pape/


New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Tue Oct 20 1998 - 21:38:58 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.