Re: OpenFlight & TRI_STRIPS

New Message	Reply	Date view	Thread view	Subject view	Author view

Marcus Barnes (marcus++at++logan.engr.multigen.com)
Fri, 2 Oct 1998 21:08:17 -0700

Next message: P J Narayanan: "Reading texture using "iopen""
Previous message: Joaquin Casillas Melendez: "Re: About RM's and channels"
In reply to: Steve Baker: "Re: About RM's and channels"

On Oct 1, 10:30am, Angus Dorbie wrote:
>Currently this is the case for most people but I think tri strips and
>now supported in the flight format.

Uhmmm ... no they are not. Creator 2.0 has mesh deformation tools, which are
pretty cool, but it writes out the result as tesselated polygons to OpenFlight.

Regards.

--
+ Marcus Barnes, Technical Staff        mailto:marcus++at++multigen.com +
+ Multigen Inc.                         http://www.multigen.com    +
+ 550 S. Winchester Blvd.               phoneto:1-408-367-2654     +
+ Suite 500 San Jose CA 95128           faxto:1-408-261-4103       +

Next message: P J Narayanan: "Reading texture using "iopen""
Previous message: Joaquin Casillas Melendez: "Re: About RM's and channels"
In reply to: Steve Baker: "Re: About RM's and channels"

New Message	Reply	Date view	Thread view	Subject view	Author view

This archive was generated by hypermail 2.0b2 on Fri Oct 02 1998 - 21:05:32 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.