Re: importing motion paths

New Message Reply Date view Thread view Subject view Author view

Marcus Barnes (marcus++at++multigen.com)
Wed, 16 Sep 1998 19:56:17 -0700

On Sep 15, 10:57am, Geoff Levner wrote:
>MultiGen allows you to choose from Bezier, B-splines or Cardinal
>splines, so reproducing the same curve from the control points should
>not be a problem. The problem is, MultiGen will not save them for you.

MultiGen Creator has better tools for this and OpenFlight v15.5 stores the
splines in the new Curve node. Curves will be supported in the Performer
OpenFlight R15.5 loader revision once it's released (no planned date yet).

Regards.

--
+ Marcus Barnes, Technical Staff        mailto:marcus++at++multigen.com +
+ Multigen Inc.                         http://www.multigen.com    +
+ 550 S. Winchester Blvd.               phoneto:1-408-367-2654     +
+ Suite 500 San Jose CA 95128           faxto:1-408-261-4103       +

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Wed Sep 16 1998 - 19:53:51 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.