bogus priority interval on bank 0

Geoff Levner (geoff++at++mclink.it)
Thu, 13 Aug 1998 14:29:33 +0200

• Next message: Daniel Williams: "what is _pfCuller doing here? (2nd try)"
• Previous message: Sujay Kumar: "(no subject)"

Can anyone tell me what this message means?

    bogus priority interval on bank 0
    bogus priority interval on bank 1
    bogus priority interval on bank 0
    bogus priority interval on bank 1
    [etc.]

I get it often when I have two clip textures in a scene, only one of
which is visible (the other is idled). The message tends to disappear if
the viewer gets close enough to the clip texture, but performance
remains slow (compared to the same scene but with only one clip
texture).

In a related question for any clip texture gurus out there, what is the
correct method for turning off a clip texture? Should it simply be
idled, like a normal texture? I have tried explicitly disassociating the
clip texture from the pipe with pfPipe::removeMPClipTexture() but have
never had any success....

Geoff

-- 
Geoff Levner -- geoff++at++mclink.it OR glevner++at++hotmail.com
Via Conca d'Oro 285, 00141 Rome, Italy

• Next message: Daniel Williams: "what is _pfCuller doing here? (2nd try)"
• Previous message: Sujay Kumar: "(no subject)"

This archive was generated by hypermail 2.0b2 on Thu Aug 13 1998 - 05:23:08 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.