DB paging

New Message Reply Date view Thread view Subject view Author view

Masahiko Yamanaka (wryperf++at++such.dst.nk-exa.co.jp)
Wed, 05 Aug 1998 16:38:43 +0900

Hello all,

My customer has developped an application using Perf2.2.
The application uses paging very large DBs and as starting it,
it works fine for a little while.

However, after paging several times, memory swap occures.

I tested page.c (% page /usr/share/data/models/X29.iv) and observed
"gmemusage", so I found the memory ratio of Irix&page increases...

Does anyone have a good way to avoid this...

Any help will be greatly appreciated!!!

Thank you,

--
M.Y. 
=======================================================================
List Archives, FAQ, FTP:  http://www.sgi.com/Technology/Performer/
            Submissions:  info-performer++at++sgi.com
        Admin. requests:  info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Tue Aug 11 1998 - 13:42:35 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.