Thomas M. Miller (miller++at++acusoft.com)
Wed, 13 May 1998 12:02:01 -0400 (EDT)
To view a demonstration (on a single pipe Onyx2) of the effect I am describing:
1) In ircombine assign the attached vfo to channel 0 and a 1280x1024_60
vfo to channel 1.
2) Save the combination to eeprom.
3) Switch your monitor cable to channel 1 while you stop and start
graphics ( be careful most monitors don't like the 180Hz
field sequential signal )
4) Run a Performer 2.2 perfly ( no DB or model required )
5) Open stats and observe frame rate.
--TMIV
On Tue, 12 May 1998, Thomas M. Miller wrote:
>
> I found a correlation between the inf/60.0 and certain video modes.
>
> My operational video mode is a 1024x768_180 stereo field sequential mode.
> If I change this mode to a 60Hz mode my frame stats go back to reading
> 60/60. Does my 180Hz video mode have adverse effects on the VClock and
> pfClock? Could this be causing timing problems other than an erroneous
> frame rate display?
>
> --TMIV
=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
Submissions: info-performer++at++sgi.com
Admin. requests: info-performer-request++at++sgi.com
This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:57:23 PDT