Re: Enabling channels

New Message Reply Date view Thread view Subject view Author view

Mario Veraart (rioj7++at++fel.tno.nl)
Mon, 6 Apr 1998 18:13:45 +0200 (MET DST)

>
> Hi,
>
> I have a dual pipe (2+4RM) Onyx2 IR with 2 DG-8 boards (16 channels). In ircombine I define (up to) 8 channels per pipe. In order to not exceed the fill bandwidth, I disable some of the channels (i.e. check off the enable switch in the channel attributes dialog).
>
> How can I during runtime enable and disabled combinations of the defined channels ?
To reduce fill bandwith you must disable the performer channel by setting
the traversal mode for the DRAW traversal to PF_OFF.

>
> Regards,
> Erik Heuer, Kongsberg Simulation & Training, 3600 Kongsberg, Norway
> E-mail: erik.heuer++at++ks-t.no Phone:(+47) 32735766 Fax:(+47) 32736965

Mario
=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:57:12 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.