vfc/ircombine question

New Message Reply Date view Thread view Subject view Author view

Clay Stanek (stanek++at++mrcsb.com)
23 Mar 98 13:22:40 +0000

I have an application that uses a non-standard resolution and frame rate
for something called the DVP (it appears as just another channel on
ircombine
 GUI).

I was successful in making my 1632x672++at++30hz format for this channel with
the
block sync template and the video format compiler (I am not really smart
enough to write my own timing source file).

I would like to display this on our super-wide monitor as well so I can
get some feel for what I am putting out over this other channel (it is a
digital interface and difficult at this point in our development to
'visualize').

So I tried using the same file for the monitor and used ircombine to make
my .cmb file with the 1632x672 ++at++ 30 Hz on both channels. ircombine
didn't complain, however the monitor did, saying the input was 'out of range'.

Is there something I don't know about acceptable line frequencies for
this monitor? Does anyone have a .vfo for the super-wide monitor that has a
30 hz swap rate and greater than 1632x672 resolution?

Platform is an 0nyx2 iR, running 6.4.

clay

Clay Stanek
R&D Scientist/ Engineer
Mission Research Corporation
735 State St. PO Drawer 719
Santa Barbara, CA 93102
805 963 8761 x306

=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:57:04 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.