smoke effect

New Message Reply Date view Thread view Subject view Author view

Charlie H. Chang (a00chc00++at++nchc.gov.tw)
Thu, 02 Oct 1997 11:15:09 +0800

Hi,

I am using pfuSmoke to create some explosion effect, and I set the
duration for
smoke and explosion. And when my application receive some signal it
will
draw the smoke and explosion. But my problem is that when two signals
are too close, I will see some ghost image of explosion and smoke above
where I set the smoke effect. I use PFUSMOKE_START to start my
explosion and smoke effects when the signal arrives. I also try to add
PFUSMOKE_STOP before start but the ghost image still exists.
Any idea how to fix this? I am using Onyx2 IR running IRIX 6.4
Performer 2.1,
and Onyx RE2 IRIX6.2. This happens on both machines.
Thank you in advance!

--
Charlie H. Chang                E-mail: a00chc00++at++nchc.gov.tw
Voice: 886-3-5776085x209        Fax: 886-3-5773620
Media & Visualization Lab, National Center for High-performance
Computing




=======================================================================
List Archives, FAQ, FTP:  http://www.sgi.com/Technology/Performer/
            Submissions:  info-performer++at++sgi.com
        Admin. requests:  info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:56:03 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.