Re: RE2 to SVGA

New Message Reply Date view Thread view Subject view Author view

Tim Crane (stereo++at++well.com)
Fri, 8 Aug 1997 06:57:13 -0700 (PDT)

The projector is probably looking for sepreate H & V sync (true VGA).
You may have to set up the projector to accept sync on green . This is
just a guess, but check along these lines.

On Thu, 7 Aug 1997 sbrown++at++nestor.ucsd.edu wrote:

> I need to send my Onxy RE2 output to an SVGA projector (800x600).
>
> I've tried a 13W3 to VGA HD15 adapter for the connection and I set the graphics
> to 800x600_60, but the projector doesn't detect the signal.
> I've tried a variety of configuration for sync configuration with no luck.
> However this configuration does display correctly on a 17" O2 monitor.
> The projector will run fine if connected to the output of a SVGA PC.
>
> Anybody know the correct way to do this?
>
> Thanks,
>
> --
> Sheldon Brown
> Assistant Professor
> Visual Arts Dept.
> University of California at San Diego
> 9500 Gilman Drive
> La Jolla, CA 92093
> voice/fax (619) 534-2423
>
> sgbrown++at++ucsd.edu
> http://www-crca.ucsd.edu/~sheldon
>
> =======================================================================
> List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
> Submissions: info-performer++at++sgi.com
> Admin. requests: info-performer-request++at++sgi.com
>
>
=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:55:43 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.