David Chan (tfchan++at++goldrush.cs.ucla.edu)
Thu, 17 Jul 1997 21:32:57 -0700 (PDT)
I attach a mztable.flt file (26KB) by using pine.
> > Since sometimes there many this kind of message while loading
> > one models, sometime no this kind message.
>
> Is there any common content to the problem files? like BSP's? or instancing? or
> rgbmode colors? etc.
The common contents I encounter are:
1) after delete some faces ( most of time this operation is ok )
2) doing some transformation to some vertex ( most of time this operation OK)
3) I do these operations in following order:
(1) paste a model say "A.flt" into another model "room.flt".
(2) doing some transformations upon pasted model "A.flt" in "room.flt"
window,
(3) output the transformated "A.flt" to another model named as "B.flt",
by using the "write select" operation,
(4) delete A.flt in "room.flt",
(5) and then externally read in the B.flt to "room.flt",
so that B.flt is in a right position after externally read in.
(After these operations, every time many that kind of messages will appear
when the model is been loaded into performer)
Note:
these operations can simply by externally read in the A.flt to
room.flt, and then doing some transformation to A.flt in room.flt window,
and then save the room.flt. But if so I encounter another problem, the
next time when I load room.flt, some transformations will not correct, so
that the A.flt is not in a right position.
Thanks.
David
This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:55:38 PDT