Re: Stencil question

New Message Reply Date view Thread view Subject view Author view

Joaquin Casillas Melendez (jcasilla++at++glup.eleinf.uv.es)
Fri, 30 May 1997 17:50:29 +0100 (WETDST)

>
> One thing that perfly does is to call pfdCombineLayers wich actually
> forces all your pfLayer mode to DISPLACE instead of STENCIL!
> This might explain the results you are getting.

  Well, I have deleted that line and I'm getting the same result. I have
checked the pfLayer mode every time and the mode is ok (PFDECAL_BASE_STENCIL)
I think that the sencil value is not correctly being updated when the
viewpoint changes, or something similar.
  
> The bad news is that there is no command line option in perfly to disable
> this behavior so you will need to comment it out and recompile.
> pfTeam: It would be nice if perfly would ship with a command line option for
> this which could be on by default.
>
> Which version of Performer are you using exactly?
         
  I am testing it in Performer 2.0 with a RE2 Onyx and also in Performer
2.1 with an O2, getting the same results.
  
>
> --
> Nicolas Gauvin CAE Electronics Ltd., 8585 Cote De Liesse
> 3D Graphics Software Saint-Laurent, Quebec, Canada, H4L-4X4
> nicolas++at++cae.ca Tel: (514) 341-2000 x2275, Fax: (514) 340-5496
>

=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:55:19 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.