caps for geometries

New Message	Reply	Date view	Thread view	Subject view	Author view

Prakash Mahesh (prakash++at++DRAWCOMP.COM)
Fri, 27 Dec 1996 12:00:19 -0500

Next message: Bill Storma: "Cancel request for fork info"
Previous message: Bill Storma: "Reserved signals for Performer"

I was creating some basic geometry nodes compliant to VRML2.0 spec. In
cases like Cone and Cylinder the spec. gives an option of either having
the caps or not (For example the Cone can be open at the bottom or
closed). I was using pfdNewCone to construct my Cone and scaled it using
a scaling matrix.
But, is there some way of opening up the cap for these geometries with
my present setup?
I would appreciate any suggestions.
Happy New Year to all!

-- 
  Prakash Mahesh                                     
  prakash++at++drawcomp.com
=======================================================================
List Archives, FAQ, FTP:  http://www.sgi.com/Technology/Performer/
            Submissions:  info-performer++at++sgi.com
        Admin. requests:  info-performer-request++at++sgi.com

Next message: Bill Storma: "Cancel request for fork info"
Previous message: Bill Storma: "Reserved signals for Performer"

New Message	Reply	Date view	Thread view	Subject view	Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:54:12 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.