Janet Estabridis (janete++at++pistilmac1.chinalake.navy.mil)
Wed, 27 Nov 1996 08:16:08 +0000
I sent a message out earlier and have not had any feedback. My problem is
this:
I had a program that used chanViewOffsets to put the eyepoint behind a
missile so that you could see the missile fly into the target. (i.e. I set
the offset 20 meters behind the missile and update the channel view to be
the current missile position for each new frame ). This was a single
channel/pipe.
Now I have modified the program to add another channel and my missile does
not show up. I am using the same chanViewOffsets command, and I have done
a get in the code and printed out where the application thinks the offset
is and that is correct. When I change the offset I can see that it moves,
SO WHERE IS MY MISSILE ???? I don't see it !!!
The missile is a DCS node attached to the pfScene. I have checked and
double checked and it does get attached and there are no errors loading in
the file.
HELP !!!
Janet Estabridis
NAWC China Lake Code 4722E0D
(619) 939-6984
=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
Submissions: info-performer++at++sgi.com
Admin. requests: info-performer-request++at++sgi.com
This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:54:01 PDT