changing framebuffer configuration

New Message Reply Date view Thread view Subject view Author view

Simon Gibbs (Simon.Gibbs++at++gmd.de)
Tue, 26 Nov 1996 14:40:45 +0100 (MET)

I have a Performer 2.1 application running on an Onyx/iR
and must switch between two framebuffer configurations:
        RGB=10, alpha=0, multisamples=8 (visual 0x90)
        RGB=12, alpha=12, multisamples=4 (visual 0x5a)

I'm creating two pfWindows, one for each configuration (where
the configuration is specified via pfWinFBConfigId or pfWinFBConfigAttrs),
putting the windows in a pfList and adding the list to a pfPipeWindow
by calling pfPWinList.

Everthing seems to be created ok, but when I try to switch to the
second configuration, pfPWinIndex complains about a bad index and I
end up with only the first configuration being used.

Has anyone had a similar experience with pfPWinIndex/pfPWinList/pfPWinIndex?

Many thanks,
Simon Gibbs

----------------------------------------------------------------------------
Simon Gibbs
GMD - German National Research Center for Information Technology
53754 Sankt Augustin
GERMANY
----------------------------------------------------------------------------
Email: Simon.Gibbs++at++gmd.de
WWW: http://viswiz.gmd.de/~simon
Tel: +49 (2241) 14.2697 (direct)
        +49 (2241) 14.2366 (department office)
        +49 (2241) 14.2040 (fax)
----------------------------------------------------------------------------

=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:54:01 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.