Russell Suter (russell++at++ctasim.com)
Fri, 15 Nov 1996 13:36:06 -0700
I have a Multigen database that took a little less than a minute to load
with pf1.2 and Irix 5.3. Since going to the IR with pf2.1 and Irix 6.2,
the load takes about 2.5 hours. Yes, that's hours. What happened. I'm
guessing that its not using physical memory but starting to do virtual
paging a little too early. The problem occures in my application as well
as perfly. The first part of the load is real fast but it reaches a point
and just crawls. Is there some parameter I can set so that RAM is prefered?
Any info would be greatly appreciated. And appologies if this topic has
been discussed.
--
Russ
________________________________________________ ______________________________
Though my eyes could see | Russell Suter
I still was a blind man. | Voice : (303) 889-1262
Though my mind could think | Fax : (303) 889-1210
I still was a mad man. | Internet : russell++at++ctasim.com
________________________________________________|______________________________
=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
Submissions: info-performer++at++sgi.com
Admin. requests: info-performer-request++at++sgi.com
This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:53:57 PDT