EnvMapping with Inventor files in perfly

New Message	Reply	Date view	Thread view	Subject view	Author view

Frank Purschke (frank.purschke++at++audi.de)
Mon, 23 Sep 1996 09:28:44 +0200

Next message: Frank Purschke: "Perfly in Dual-Pipe Mode on IR"
Previous message: Angus Dorbie: "Re: Texture quality on RE2/RE3."

Here is another one on perfly:
I have problems to get an environment mapping on inventor objects in
perfly. The following inventor sample describes a little bit closer what
I mean:

Inventor file: test.iv
---------------------------
#Inventor V2.0 ascii

Separator {
    TextureCoordinateEnvironment {
    }
    Texture2Transform {
        center 0.5 0.5
    }
    Texture2 {
        filename "/usr/share/data/textures/reflect/cafe.rgb"
        model MODULATE
    }
    Cube {
    }
}

This small example works fine with ivview but it fails with perfly.
Any hints would be very helpful!

Frank

-- 
Frank Purschke
Volkswagen AG
Virtual Reality Lab
=======================================================================
List Archives, FAQ, FTP:  http://www.sgi.com/Technology/Performer/
            Submissions:  info-performer++at++sgi.com
        Admin. requests:  info-performer-request++at++sgi.com

Next message: Frank Purschke: "Perfly in Dual-Pipe Mode on IR"
Previous message: Angus Dorbie: "Re: Texture quality on RE2/RE3."

New Message	Reply	Date view	Thread view	Subject view	Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:53:36 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.