Re: gamma system value in MCO mode?

New Message Reply Date view Thread view Subject view Author view

Eric Tran (etran++at++cgsd.com)
Mon, 12 Aug 1996 12:29:45 -0700 (PDT)

On Sat, 10 Aug 1996, Simon Bennett wrote:
> On Fri, 9 Aug 1996, Todd R Pravata wrote:
>
> > Is there any trick to setting the gamma when running the MCO on an
> > RE2? It doesn't seem to take effect when the MCO is running but works
> > fine without it. Any suggestions?
>
> Use mcogamma.

You can also use the "vout" utility to set
the gamma value once the mco is running.

Usually, you don't have a screen after the
mco is on, so you will have to setenv DISPLAY
to another machine. Then run "vout"

One problem, however, I have not been able
to tell "vout" to save the setting so I have
to do this everytime. If you have better luck,
let me know.

Eric Tran.
-------------------------------------------
Computer Graphics Systems Development Corp.
(415)903-4930 (415)903-4932
Fax: (415)967-5252

=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer/
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:53:20 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.