showcase and performer

New Message Reply Date view Thread view Subject view Author view

David Chan (tfchan++at++cs.cuhk.hk)
Sun, 23 Jun 1996 14:51:34 +0800 (HKT)

Hi,
        Does any one try to use showcase 3.3.3 to build 3D models, then save it
as 3D inventor format, and then load the inventor format (v1.0) to
perfly, where perfly is the new one: using the newest inventor loader for
performer 1.2.
        The problem is:
        the models after been loaded to perfly, and using the drive mode,
the model(e.g a cube) can be pass through.
        I have try to use indowngrade to change the file to inventor vesion
2 format, but the problem is still exist.
        And when i load other inventor format file not created from
showcase, the model can't be pass through, why?
        And how can i use showcase to creat 3D models, which can't be pass
thourgh in performer.
        Thanks for any hints and ideas.

        tfchan++at++cs.cuhk.hk
        David

=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer.html
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:53:02 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.