Coplanar polys w/ texture

New Message Reply Date view Thread view Subject view Author view

cstanek++at++smtpgate.sm.tsc.com
Tue, 04 Jun 96 09:25:15 PST

      
     Sometimes I need to snap screen images with perfly on our Indigo2 XZ
     running 5.3 and pf2.0. To do this, I position where I want to be and
     then enable texturing.
      
     Coplanar polygons that are properly layered render with no flimmering
     when I squeeze my clipping planes together, as expected. However,
     when I turn on texturing, I get a mess. Is it possible for coplanar,
     textured polygons to render properly on an Indigo2 XZ with texturing
     enabled or is the poor guy too graphically challenged in this
     scenario? (While "buy an impact board" is a fine response, I won't
     find it a terribly helpful reply ;) )
      
     Thanks,
      
     Clay
      
     --
     Clay Stanek
     Technology Service Corp. | voice: (310) 450-9740 ext 348
     2950 31st Street | fax: (310) 452-3175
     Santa Monica, CA 90405 | e-mail: cstanek++at++tsc.com
     --

=======================================================================
List Archives, FAQ, FTP: http://www.sgi.com/Technology/Performer.html
            Submissions: info-performer++at++sgi.com
        Admin. requests: info-performer-request++at++sgi.com

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:52:58 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.