setting texture coordinates

New Message Reply Date view Thread view Subject view Author view

AnitaKishore (kishore++at++electrogig.com)
Tue, 27 Feb 1996 12:11:03 -0800

I am doing texture coordinate translation in the DRAW process by obtaining
the current coordinates, updating them as needed and setting it back again
on to its geoset. I want to know if there is a way to do this from the APP
process too. I have tried following the same procedure in the APP process,
but the new coordinates do not take effect. I thought it would be possible
because initially all geometry is created and assigned texture coordinates
from the APP process. So why can't I change it later on from within the same
process?

Any ideas/help would be appreciated.

thanks
-anita

-------------------------------------------------------------------------
Anita Kishore
kishore++at++electrogig.com
-------------------------------------------------------------------------

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:52:27 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.