Re: SIF Format

New Message Reply Date view Thread view Subject view Author view

Gene McKenna (mckenna++at++cgsd.com)
Mon, 15 Jan 1996 13:37:35 -0800

At 8:48 AM 1/15/96 +0100, Eric Menu wrote:
>Hello,
>
>I'm searching for a conversion program from SIF format to Inventor format
>(or any format supported by perfly). So, if anyone can send me sources
>with a SIF loader, that could help me a lot.
>
>(SIF is the Standard Interchange Format defined by the 1821 project.)
>
>In a more general context, I'm interesting to all conversion programs.
>
> Thanks,
> Eric.

I can't tell you how to get to Inventor (or anything else really) but I can
tell you who to contact.

Don Lien (pronounced Line) at the Simulator Data Base Facility (SDBF)
at Kirtland Air Force Base, NM. He is very helpful, as is a woman there
named Melanie.

        SDBF (505) 262-9340

Their web site has a SIF toolkit which may or may not be helpful to you.
        http://sdbf.irk.aetc.af.mil/

We just converted some texture patterns to SIF texture pattern format.
I assume you are using the geometry data.

You may not find any code to the do the conversion for you, but if you
get Mil Standard 1821 you can probably write your own.

Good Luck

GENE

\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
\\ Gene McKenna \\
\\ mckenna++at++cgsd.com CGSD Corporation \\
\\ voice 415.903.4928 Software Engineer \\
\\ fax 415.967.5252 Webmaster www.cgsd.com \\
\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:52:15 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.