Window Border

New Message Reply Date view Thread view Subject view Author view

lelkins++at++relay.nswc.navy.mil
Fri, 5 Jan 96 15:15:51 EST

I've got what (I hope) is a quick question...

I'm rewriting a Performer application to work with an HMD. The
HMD in question wants a particular video mode (645x486_30i).

I used setmon to get into 645x486_30i, then pfuGLXWinopen to open a
645x486 display.

I had expected that if I asked for a window as large or larger than the
root window, I would get a window with no border. However, I'm getting
one. Looking at xwin.c, it appears that pfuGLXWinopen should default
to no border. After fiddling a little more, I found that I get a border
for all sizes up to 1280x1024. When I make a request that large, the
border goes away... So is this an X thing where it does not recognize
the reset window sizes automatically?

Presumably, I need to use pfuGLXCreateWindow to specify a borderless
window. I've looked through the archives and still haven't figured
where to get the "pfuXWindow parent" parameter from given the Xdpy.
Can someone point me in the right direction?

Thanks from the X-challenged,

Les

----------------------------------------------------------------------
lelkins++at++relay.nswc.navy.mil The views expressed herein do not
                                   represent those of NSWC, the Navy,
Les Elkins or the federal government.
Naval Surface Warfare Center
Dahlgren Division (And anybody who says otherwise is
Silver Spring, MD itching for a fight...)

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:52:14 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.