Re: Question on I/O devices

New Message Reply Date view Thread view Subject view Author view

Wes Bethel (wes++at++mh1.lbl.gov)
Mon, 27 Nov 1995 08:06:13 -0800

i've run the fastrak at 19.2 with no problems. don't forget that there
are some dip switches on the fastrak PCB that require tweaking when you
change baud rates.

wes

  + From: mcmillan++at++cs.nps.navy.mil (Scott McMillan)
  + Did anybody ever interface the Fastrak to a standard serial port (no ASO's
  + please) on any of the SGI's using the hardware handshaking cable and actually
  + get data from the unit with a baud rate higher than 9600? I had no luck on
  + my Indigo2 and finally had to settle for the 16BIT format and 16Hz sample
  + rates. I assume that with the right cable, I can exceed 9600 baud because the
  + modem in the other serial port runs at 19.2K or 38.4K.
  +
  + scott

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:52:03 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.