N-Vision HMD

New Message Reply Date view Thread view Subject view Author view

Axel Sammet (axel++at++elwood.hannover.sgi.com)
Wed, 19 Jul 1995 09:07:25 +0000

Hi Folks,

Has anyone successfully connected an N-Vision HMD to an ONYX RE2 using
field sequential output mode?

The setmon command I am using is:

setmon -n -sb 1280x960_180qi

I have a 13W3 to 3BNC cable connected to the Monitor outlet and connected
the HMD to the Blue Cable (where the sync is on).

I have an application in 24-Bit RGB mode running and expect a color image
on the HMD display.

Unfortunately I only get a B&W signal on the HMD as well as on my field
sequential control monitor.

I have another FieldSequential control monitor with three BNC inputs (one
for each color component). This one works perfectly so I might still have
an RGB parallel signal and not the expected sequential.

Are there ways to check the fieldsequential signal which leaves the ONYX?
Has anyone experienced similar problems?

Any help and hints greatly appreciated.

Thanks

Axel

-- 


______________________________________________________________________


      _/_/_/_/_/   _/_/_/_/_/   _/
     _/           _/           _/
    _/           _/           _/
   _/_/_/_/_/   _/  _/_/_/   _/
          _/   _/  _/  _/   _/
         _/   _/      _/   _/
_/_/_/_/_/   _/_/_/_/_/   _/


Axel Sammet, SE
Visual Simulation, Digital Media, CAD/CAM


Silicon Graphics GmbH         | Tel:    +49 511 9017229
Ahrensburger Strasse 3        | Fax:    +49 511 6138115
30659 Hannover                | VM #:   59191  M/S: IHA-314
Germany                       | E-Mail: axel++at++hannover.sgi.com
                              | URL:    http://www.hannover.sgi.com/
_____________________________________________________________________

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:51:41 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.