Re: SoTransform node having "DCS" or "dcs" in its name

New Message Reply Date view Thread view Subject view Author view

Jim Helman (jimh++at++surreal)
Sun, 11 Jun 95 22:35:53 -0700

Version 1.5 of LoadIv has a bug in that it only converts a
transform to a DCS when an SoGroup or SoShape that inherits that
transform has "dcs" or "DCS" in its name. There's also another
potential problem in the inheritance of transforms when you are
only converting *some* of the SoTransforms into pfDCSes and other
subsequent geometry expects to inherit the transform.

I've put out a new version of the Inventor loader that also has
some support for SoRotor, SoShuttle and SoPendulum. However,
tread lightly before relying on it. Not only where these changes
substantial, but I went further and also synced it back up with
our current Performer 2.0 development version.

        ftp://sgigate.sgi.com/pub/Performer/pfiv1.6.tar.Z

rgds,

-jim helman

jimh++at++surreal.asd.sgi.com
415/390-1151

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:51:35 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.