Re: Swap Ready on the Onyx

New Message Reply Date view Thread view Subject view Author view

Axel Sammet (axel++at++elwood.hannover.sgi.com)
Fri, 28 Apr 1995 07:58:16 +0000

Hi Simon,

i had a similar problem in the past which made me think the SwapReady may
not be connected.
And indeed:
There is a black/red twisted cable connected to the DG2 Board. This cable
may be connected to two different pairs of pins which are about 1 1/2 inch
apart. If this cable is connected to the upper pins , the SwapReady will
only show noise, while being connected to the lower pins the SwapReady
delivers the correct signals.

Let me know if this helps to solve your problem.

Regards
Axel

-- 


______________________________________________________________________


      _/_/_/_/_/   _/_/_/_/_/   _/
     _/           _/           _/
    _/           _/           _/
   _/_/_/_/_/   _/  _/_/_/   _/
          _/   _/  _/  _/   _/
         _/   _/      _/   _/
_/_/_/_/_/   _/_/_/_/_/   _/


Axel Sammet
Visual Simulation, Digital Media, CAD/CAM
Silicon Graphics GmbH         | Tel:      +49 511 9017216
Ahrensburger Strasse 3        | Fax:      +49 511 6138115
30659 Hannover                | VM #:     59191  M/S: IHA-314
Germany                       | E-Mail:   axel++at++hannover.sgi.com
______________________________________________________________________

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:51:26 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.