another problem of importing dxf into performer

New Message Reply Date view Thread view Subject view Author view

Jung-Ju Choi (jjchoi++at++cherry.postech.ac.kr)
Fri, 17 Mar 1995 17:58:20 +0800 (KST)

Hi, all subscribers.

In using perfly/pickfly, it does not importing some dxf files.
Sometimes, it does importing other dxf files.
I think there are two differents between two dxf files.
The one, which can be imported, is DXF version 10 and no POLYLINE entity but
only 3DFACE entity.
The other, which cannot be imported, is DXF version 12 and with some
POLYLINE entities and 3DFACE entities.

Is there another improved pfdxf.c for importing dxf into performer ?

-- 
  _ _ /|    Jung-Ju Choi
  \'o.++at++"    Graphics Lab., Dept. of CS, PIRL, POSTECH
  =(___)=   jjchoi++at++cherry.postech.ac.kr, jjchoi++at++snoopy.postech.ac.kr
     U      http://hobak.postech.ac.kr/~jjchoi/

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:51:05 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.