Blended LODs

New Message Reply Date view Thread view Subject view Author view

Angus Dorbie uid (angus++at++division.demon.co.uk)
Wed, 2 Nov 1994 12:43:38 +0000

Hi all,
        are there any plans to support selectively blended LODs in performer
rather than globally setting a single blending range for all transitions drawn
to a channel? Using traversal callbacks for this seems cumbersome and would
only allow me to switch blend ranges for a single pfLOD (assuming it works),
not individual transitions between geometries.
Ideally I'd like to specify blend ranges in the same manner as I specify LOD
ranges. This would allow selective switching or blending between the models
below the same pfLOD.

-- 
________________________________________________
 Angus Dorbie                 Division Ltd,
 Software Engineer            19 Apex Court,
 Tel: (01454)615554           Woodlands,
 Fax: (01454)615532           Bristol BS12 4JT,
 angus++at++division.demon.co.uk   UK
________________________________________________

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:50:38 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.