Problem with pickfly on 2 Pipe System

New Message Reply Date view Thread view Subject view Author view

Reed Whittington (reedwhit++at++skips.dseg.ti.com)
Tue, 24 May 94 10:34:12 CDT

We have been working with the pickfly example code trying to develop a target
tracker. pickfly works fine on our single pipe Onyx RE2 wo MCO, but has
problems on both of our 2 pipe Onyx RE2s w MCO.

To recreate problem on a 2 pipe system:
pickfly somemodel.xxx # this has problems
pickfly -c 1 somemodel.xxx # this works fine

The symptom is this:
pickfly lets you move and pick once and then no more mouse
interaction is possible.

Some information on our 2 Pipe Onyx RE2 w/ MCOs.

hinv:

4 150 MHZ IP19 Processors
CPU: MIPS R4400 Processor Chip Revision: 5.0
FPU: MIPS R4010 Floating Point Chip Revision: 0.0
Data cache size: 16 Kbytes
Instruction cache size: 16 Kbytes
Secondary unified instruction/data cache size: 1 Mbyte
Main memory size: 128 Mbytes, 2-way interleaved
I/O board, Ebus slot 9: IO4 revision 1
I/O board, Ebus slot 11: IO4 revision 1
Integral EPC serial ports: 4
RealityEngineII Graphics Pipe 1 at IO Slot 9 Physical Adapter 6 (Fchip rev 2)
Multi-Channel Option board installed
RealityEngineII Graphics Pipe 0 at IO Slot 11 Physical Adapter 2 (Fchip rev 2)
Integral Ethernet controller: et0, Ebus slot 11
Integral SCSI controller 91: Version WD33C95A
Integral SCSI controller 90: Version WD33C95A
Integral SCSI controller 1: Version WD33C95A
Disk drive: unit 1 on SCSI controller 1
Integral SCSI controller 0: Version WD33C95A
Tape drive: unit 7 on SCSI controller 0: QIC 150
Tape drive: unit 6 on SCSI controller 0: DAT
CDROM: unit 5 on SCSI controller 0
Integral EPC parallel port: Ebus slot 9
Integral EPC parallel port: Ebus slot 11
VME bus: adapter 0 mapped to adapter 45
VME bus: adapter 45

gfxinfo:

Graphics board 0 is "REV" graphics.
        Managed (":0.0") 1280x1024
        Display 1280x1024 ++at++ 60Hz
        12 GE (GE10 rev. 0x7)
        4 RM4 boards
        Large pixel depth
        10-bit RGBA pixels
        Not using Multi-Channel Option
Graphics board 1 is "REV" graphics.
        Managed (":0.1") 1280x1024
        Display 1280x1024 ++at++ 60Hz
        12 GE (GE10 rev. 0x7)
        2 RM4 boards
        Medium pixel depth
        10-bit RGBA pixels
        Not using Multi-Channel Option

uname -a:
IRIX snoopy 5.2 02282015 IP19 mips

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Mon Aug 10 1998 - 17:50:17 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.