From: Marcin Romaszewicz (marcin++at++sgi.com)
Date: 07/31/2002 15:47:01
Run "glxinfo" on your octane, and it will list all the available
visuals. My MXI does not support IA visuals at all, but it can do 12 bit
intensity-only visuals. I don't know about EMXI, but I suspect its the
same.
Octane2 or Fuel workstations with VPro graphics support IA 12/12 if I
remember correctly. An IR can do IA 16/16
-- Marcin
On Wed, 31 Jul 2002, ken sartor wrote:
>
> Hi -
>
> I have an Octane with EMXI graphics. What is the maximum bit depth i can
> get for intensity-alpha channels? I am hoping to get 16 bit resolution...
>
> If my Octane (hinv output of it below) does not support this, can you point
> me to the minimum machine that does?
>
> TIA.
>
> ken
>
>
>
> seven % hinv
> 2 300 MHZ IP30 Processors
> CPU: MIPS R12000 Processor Chip Revision: 2.3
> FPU: MIPS R12010 Floating Point Chip Revision: 0.0
> Main memory size: 512 Mbytes
> Instruction cache size: 32 Kbytes
> Data cache size: 32 Kbytes
> Secondary unified instruction/data cache size: 2 Mbytes
> Integral SCSI controller 0: Version QL1040B (rev. 2), single ended
> Disk drive: unit 1 on SCSI controller 0
> Tape drive: unit 3 on SCSI controller 0: unknown
> Integral SCSI controller 1: Version QL1040B (rev. 2), single ended
> CDROM: unit 4 on SCSI controller 1
> IOC3 serial port: tty1
> IOC3 serial port: tty2
> IOC3 parallel port: plp1
> Graphics board: EMXI
> Integral Fast Ethernet: ef0, version 1, pci 2
> Iris Audio Processor: version RAD revision 12.0, number 1
>
This archive was generated by hypermail 2b29 : Wed Jul 31 2002 - 15:47:15 PDT