From: Ozarka Simatomi (chumanlu++at++yahoo.com)
Date: 05/29/2002 10:42:15
Hi,
I am using DTI 3D flat panel to generate stereo
vision. I am not sure about how to set the offset of
the two channnels corresponding to the two eyes.
I made left channel to be the master and attached
the right channel to it. I first set the view point of
the left channel, then I set the view offsets for the
right channel.
I am not sure about the meaning of the hpr vector.
In the Getting Started Guide, it says hpr means the
relative rotation angles of slave camera to the master
camera about the x, y, and z axes. This is different
from the definition of the hpr vector used to set the
camera view position, which defines hpr as heading,
pitch, and roll.
If I want to rotate the slave camera about the z
axis for 10 degrees, should I make a hpr vector (0,0,
10), or (10, 0, 0)?
Thanks a lot!
wei
__________________________________________________
Do You Yahoo!?
Yahoo! - Official partner of 2002 FIFA World Cup
http://fifaworldcup.yahoo.com
This archive was generated by hypermail 2b29 : Wed May 29 2002 - 10:42:31 PDT