[info-performer] pfBillboards in multipipe

New Message Reply Date view Thread view Subject view Author view

From: Marco O Lanzagorta (lnzgrt++at++cmf.nrl.navy.mil)
Date: 05/20/2002 09:28:13

Hello,

I am working on a Performer application that uses pfbillboards, and
it works fine in a single pipe. However, when I go to multipipe, the
billboards do not show at all. Except sometimes where strange artifacts
can be seen in the different windows.

Any idea of what I may be doing wrong? Is there a special way to set the
billboards to be shown in more than one pipe?

Thanks,

Marco

===========================================================================
Dr. Marco Lanzagorta email: lnzgrt++at++cmf.nrl.navy.mil
Code 5594 phone: (202) 767-8427
Center for Computational Science fax : (202) 404-7402
Naval Research Laboratory
4555 Overlook Ave, S.W.
Washington, DC 20375 http://ohm.nrl.navy.mil/staff/lnzgrt
===========================================================================

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Mon May 20 2002 - 09:28:50 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.