Network code in Performer

New Message Reply Date view Thread view Subject view Author view

From: Rob Body (rdb++at++hrwallingford.co.uk)
Date: 10/04/2001 06:10:27

Hi everyone,

I have an application that currently talks to an ONYX RE2 using the serial
port but I am finding that this is too slow. It currently runs fine at 9600
baud but when I try to increase it baud rate I lose some of the data. Does
anyone know how I can use TCP/IP from within Performer to do transfer this
data instead ? Any pointers in the right direction would be greatly
appreciated. :-)

Thanks in advance.

Rob

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Rob Body
Simulator Manager

HR Mardyn
HR Wallingford
Howbery Park
Wallingford
Oxon
OX10 8BA

Tel 01491 822327
Fax 01491 832233

e-mail r.body++at++hrwallingford.co.uk

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-
HR Wallingford uses Faxes and Emails for confidential and
legally privileged business communications. They do not of
themselves create legal commitments. Disclosure to parties
other than addressees requires our specific consent. We are
not liable for unauthorised disclosures nor reliance upon
them. If you have received this message in error please
advise us immediately and destroy all copies of it.
-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Oct 04 2001 - 06:14:53 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.