Balancing frame swap times in DPLEX/hyperpipe mode

New Message Reply Date view Thread view Subject view Author view

From: Richard Spencer (spencer.richard++at++epamail.epa.gov)
Date: 02/27/2001 14:52:17

I am using perfly to view a large model (> 1 million polygons) in
hyperpipe (-M2) mode on a two pipe (with DPLEX) Onyx 3400.

The time between the start of the Pipe 0 frame and the start of the
Pipe 1 frame is much less than the subsequent time between the start
of the Pipe 1 frame and the Pipe 0 frame. Overall frame times are the
same on both pipes.

How can I force these (swap) times to balance out for a smoother
result?

Many thanks 

-- 
Richard M. Spencer                   Lockheed Martin Services Group
EPA Scientific Visualization Center  86 T.W. Alexander Dr, MD 24A, ERC
mailto:spencer.richard++at++epa.gov       P.O. Box 14365; RTP, NC 27709  USA
http://www.epa.gov/vislab            Tel:919-541-0022, Fax:919-541-0056

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue Feb 27 2001 - 14:52:37 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.