Pf <=> DXF

New Message Reply Date view Thread view Subject view Author view

From: Dirk Scheffter (scheff++at++iff.fhg.de)
Date: 01/16/2001 05:27:18

pfHi,

just writing a DXF exporter for IRIS Performer.

I assume some errors in the default DXF loader.
(OK, OK, I know it's just a sketch. And it was very useful for me in the
past.)

However, it seem's not to be able to handle polymeshes correctly. I'm not
sure but dxf2flt was able to handle my output correctly. May be the
specification of DXF is not clear enough about polymeshes.

Has anybody done work on this topic?

pfGreetings,
Dirk.

-----------------------------------------------------------
Dipl.-Inf. Dirk Scheffter scheff++at++iff.fhg.de
Fraunhofer IFF fon: +49 (0) 391/40 90-854
Sandtorstr. 22 fax: +49 (0) 391/40 90-870
D-39106 Magdeburg http://www2.iff.fhg.de/~scheff
Germany
-----------------------------------------------------------

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue Jan 16 2001 - 03:35:24 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.