From: Don Burns (don_burns++at++peru.engr.sgi.com)
Date: 11/03/2000 09:23:02
Disclaimer : This is not an official Performer response, but... The following
would probably work for you:
o Create four channels all in the same viewport
o Set a channel DRAW callback for each and pass in the integer relating to
the board number you want to use for each
o At the top of the channel DRAW callback, call fxMesaSelect....
-don
On Nov 3, 3:57pm, Erik Masson wrote:
> Subject: Does pf for Linux support Multi-pipes ?
>
> Guys,
>
> I was wondering if pf supports multi-pipe under Linux ? I've got a
> nice SGI 1200L with 4 Xeon CPU and 4 x 3Dfx V2 cards...
>
> I can make used of all cards under Mesa3.x by calling
> fxMesaSelectCurrentBoard(n), where n is the channel or the card number
> that you wish to work on.
>
> Any tough on that ?
>
>-- End of excerpt from Erik Masson
This archive was generated by hypermail 2b29 : Sat Nov 04 2000 - 15:27:00 PST