pfLODs

New Message Reply Date view Thread view Subject view Author view

From: Sakns (gaitat++at++yahoo.com)
Date: 10/04/2000 08:59:56

Hi there,

One of the tips in the performer manuals says that for best
results, specify ranges (pfLOD) only where necessary; give
browsers as much freedom as possible to choose LODs based on
performance and system stress.

Can someone elaborate a little bit on this one.
I set up a pfLOD node without ranges at all and none of the lods
show up. Then I only set up the first and the last ranges, and the
lod never switches to the high level. It always stays with the
low.
When I setup the correct ranges then it works as expected.
I only have 3 objects under the LOD node.
So what does the tip mean?

Thank you.

=====
Athanasios Gaitatzes (Saki)
e-mail: gaitat++at++yahoo.com
   url: http://www.i.am/gaitatzes

__________________________________________________
Do You Yahoo!?
Yahoo! Photos - 35mm Quality Prints, Now Get 15 Free!
http://photos.yahoo.com/

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Wed Oct 04 2000 - 09:00:02 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.