Re: Error message!

New Message Reply Date view Thread view Subject view Author view

From: ross barna (rbarna++at++neochi.com)
Date: 05/18/2000 14:09:32

did you ever figure out what went wrong? when i use PFMP_DEFAULT i get that
error on a multipipe multiproc octane. if i use PFMP_APPCULLDRAW i don't get
the error.

how did you fix your problem?

Hi everyone,
   I have a quick question that I hope someone will be able to answer.
Could someone tell me what the following error message means?

"GL: Error: can't get gfx info"

Thanks,
Dan Oberlin

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu May 18 2000 - 14:14:24 PDT

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.