Onyx2 Single Pipe -> 3 Pipe

New Message Reply Date view Thread view Subject view Author view

From: Devrim Erdem (devrim++at++infotron.com.tr)
Date: 03/11/2000 05:48:01

Hi,

I need to develop a performer application on an Onyx2 single pipe machine and have this application work on a 3 pipe onyx2 rack system. As I don't
have the 3 pipe machine at the development site, I am afraid of any problems related to the architectural changes between these two systems. Though
Performer would save me from many changes, I would like to hear if there are any possible problem sources. Any ideas on the issue are very much
appreciated.

Software will be based on Vega+Performer, will have 3 channels on Single pipe machine and 3 windows on the 3 pipe machine when transition if complete.

My app needs to run at 60 Hz at the 3 pipe machine and my understanding is that 3 pipe machine can do 11M polygons per pipe and 1 pipe desk side has
the same capability. Would it be correct if I assume that each pipe can have up to 11 M polygons ( yes I know this number shall be divided by x ) on
the 3 pipe machine.

Thanks, 

--
/*===============================================
M. Devrim Erdem            devrim++at++infotron.com.tr
                  Simulation Software Development
                              info(+)TRON, Turkey
Tel: +90 216 4921002
Fax: +90 216 3432132
http://www.infotron-tr.com
http://abone.turk.net/mderdem
===============================================*/

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Sat Mar 11 2000 - 05:46:53 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.